9/11 Physics: THE Death Blow to the Official Fairy Tale

I wanna add a bit to my angle,steel.What would steel have shown if actual samples were chain-of-custody-assured tested,in layman[sic]terms?The process is simple.You collect beams,labeled as to origin,orientation,etc.Then you cold saw specimens and polish them to a high degree of flatness,in a special grinder,pains taken to prevent grain distortions induced thereby.A stain is applied and micro photographs taken.Then contrast and compare to known specimens.

So,what if bombs went off in the various locations alleged by the Truthers and Apostate Trusters?We would see some curiously bent beams,that's what.And within those beams,the grain of the steel has been altered in such a way that the only way to re-establish a normal grain,you would have to forge at a high temp with resulting reduction in section of over 30%.The grain of steel can be thought of a series of crystals that are strongly magnetic but not stuck.So when you shock the steel into moving,the crystals all align in rough rows and rotate and slide a tiny bit,leaving apparent rows,looking like waves in calm water,or ripples.That pattern may be seen in a common baking pan in the corners where the metal has been formed,Leuder's lines.The bigger the shock,the smaller the ripples.Micro-testing reveals confirming details.

Specimens of the same steel can be tested after being explosively shocked to add another confirmatory parameter.Either saved samples or from sections of beam from the building not distorted but same batch.

And,(let me tighten the old tin foil...)If hijackers done it and dumped jet fuel and computers and whatever blew up in an office filled with normal not flammable carpets,drapes,paperless as much as possible office supplies(must tighten hat)TRANSFORMERS ya that's the ticket it blew up and weakened the beams,which gave way and the building fell,OK?And the jet fuel.Nobody knows.Were you there?

(loosen)The beams would have been subject to unknown,but well quantifiable stresses with resulting strains.But orders of magnitude less than initial explosions.Why?Well as a cascading pile of debris,the beams would be the parts doing the mashing,being the biggest hardest components,only being overpowered by the bigger beams.But also supported by the concrete and smaller re-rod and such.There was a LOT that would have been revealed by a proper inverstigation which is now lost.Chain of custody has been severed.Also,if,back to Truth finder camp,here,If steel was vaporized,it was only HALF vaporized in some cases and the zone of WTF would be plain to see.In plane site?????Questions?

[edit on 19-2-2010 by trueforger]