The first of these to be built was in 1946 in the Northern Mountains of New Mexico by Bechtel Corp. near El Vado Lake, NM. On July 2, 1947 one of the
first DNF’s took place due to a radar anomaly that affected the energetic magnetic properties of the Xerum 525 contained within the core generator.
A Second DNF took place outside of Aztec, NM 1948 and throughout 1949 and 1950’s in the Farmington, NM Press reports of seeing these test vehicles;
the second site was built at Raven Rock, PA. referred to by SOC Special Operations Command as “Site R” in 1950; the third base was built in 1953
and run by Army Intelligence near Ft. Greely Alaska; to this day; I would say this is the most secure and established advanced technologies center
that the US Government has to offer; having worked there myself on many occasions.
So many of you right now, are probably saying out loud; “What about AREA 51, S1, S4 or the Groom Lake Facility?” this facility is referred to by
the Puzzle Palace as a “Shamurai”. This facility was a decoy base, used to draw the attention away from the real sites; as well as a test flight
facility for more standard advanced aircraft.
The first complete description of Kammler’s Bell by the public, took place Dec. 9, 1965 in Kecksburg, PA; eye witnesses from four different states
as well as, eye witnesses on the ground described Kammler’s Bell almost in perfect detail.
I hope, I am making myself as clear as I can possibly be; these crafts although very real in nature are not other worldly in the least, on the
contrary they are designed by us. This is an example of the standard propulsion core used on-board these crafts.
Propulsion System
Fluid Substance
Xerum 525
Thorium Hydroxide (Th(OH)4)
Beryllium Fluoride
Cinnabar Mercury (mercury (II) sulfide (HgS)
Iridium-192
Silicone Dielectric Gel
Lithium Fluoride
Deuterium Oxide
The above materials have changed over the years, this is not the original formula of the mixture first conceived by Dr. Kammler and his research team;
however these substances when combined show the highest potential of particle energetics and is the current mixture of the substance. The mixture
above when tuned to the proper fermionic field; creates three major outputs, (.1 Mass amounts of Kinetic Energy, .2 An outer-core Spinor Field equal
to 0, .3 A Flux Inverse Quantum Magnetic Field) this fluid however has to be extremely shielded during operation, because of the massive amount of
radiation that is emitted from the core generator.
Inner Core Structure
The inner-core structure is comprised of an alloy mixture of, magnesium, beryllium, and barium. It can range in sizes from very small (diameter of
.5’) to very large, the biggest of which I have personally seen (diameter of 18’)or; this is an estimated guess on my part as I was not given the
chance to physically measure the device. The inner-core contains the fluid solution as described above.
Outer-Core Structure
The outer-core is comprised of a strontium phosphate glass insulator with a vacuum space in between the inner-core and outer-core; depending on the
application of the core this can vary in thickness; the propulsion cores insulator is several inches thick; with maximum vacuum gap in between. This
outer shell is impregnated with (NMR) Nuclear Magnetic Lasers; which are utilized as the tuning forks for the inner core. The intensity level
(resonance) of the NMR regulates not only the amount of kinetic and magnetic energy released but, depending on which NMR’s are fired in specific
sequences gives you direction as well.
Power Source
The power source for the unit is a specially designed battery system comprised of finely made lattice silicon sheets riddled with pits 40 microns
thick; they are then cutout and constructed into hollow dodecahedrons and coated with iridium-192. You then stack them on-top of each other placed
inside a hermetically sealed cylinder. The cylinder is then filled with radioactive tritium gas; this is the equivalent of taking several hundred
solar panels and dropping the sun into to the center of them. The number of battery cells needed depends on the size of the core generator you are
using.
Because, I realize many of you members will not understand the technology or the science I just described above, you may dismiss this all together or
simply claim that this is made up science fiction. All I can say is, “Find a Physicist” any decent physicist will understand the principles being
used and the process that are being used.
The outer-casing of the craft depends on its function; there are ABU’s Airborne Units; UBU’s Underwater Based Units; and DMU’s or Dimensional
Units. I will not go into full detail with anyone in particular just for the plain reason it would take too long to explain each one separately.
I was going to go into people who have been abducted and the purposes behind such abductions but, I just looked down and noticed this paper is six
pages long already. Therefore I will go into that at a later date, after I see the response of this thread. I know this will only open more questions
than answers for most of you on ATS but, I hope there are some out there that got some answers as well.
Respectfully
MolecularPHD
You may read these supporting documents at your leisure:
greyfalcon.us...
arxiv.org...
www.scribd.com...
en.wikipedia.org...
en.wikipedia.org...
www.ufocasebook.com... (this site got the date wrong)